Lot 0 - Delapena E2000 CNC Honer

Description:

Delapena E2000 CNC Honer

Honing Machine with a fully programmable electronic management system.
Multi stage expansion to allow rough and finish in single set up.

Suitable for honing large batches of high precision parts

Maximum bore: 120 mm
Stroke length: 350 mm

Technical Specification

Diameter Range
- 114-120.00mm

Spindle Motor
- 3 kW high torque (6 pole)

Spindle Speed
- 150-3500 rpm Infinitely variable

Stroking Motor
- 1 .5 kW servo

Stroking Length
- 2.00-300.00 mm Infinitely variable to 0.1mm increments

Stroking Speed
- 0.1-25 m/min. Infinitely variable

Short Stroking
- Fully programmable, length and frequency

Stone Feed
- Up to four stages of feed with variable increments of time

Stone Pressure
- Variable increments approximately 1000 N

Controller
- Gehring digital honing control system

Honing Fluid Filtration
- Three stage, magnet, fabric and weir capacity 75 litres

Electrical Equipment
- Conforms to IEC 204 European Standard BS2771 British Standard 24 V DC control

Electrical Supply
- 380/420 V, 3 ph, 50 Hz

Hardly used

Location: Coventry

Export Information

Please note: If you are successful in purchasing an item and wish to export it from the UK, a charge of £75.00 will be automatically added to your invoice to cover preparation of the goods and completion of the required UK export customs declarations. This process has been a mandatory UK export requirement since 1 January 2021.

All invoices are issued on an Incoterms FCA basis.

Exports outside the EU may require an export licence. Where applicable, a further charge of £250.00 will be automatically added to your invoice. Please also note that, while an export licence is being processed, the purchaser is responsible for placing into storage until the licence is issued.

* Please note all dimensions stated are approximate, however the accuracy cannot be guaranteed and should be verified by the bidder before bidding.

Recommended Transport 

Bid information