Downstroke Hydraulic Press

Lot 4 - Downstroke Hydraulic Press

Description:

Top & bottom platen temperature controls - adjust using the central up & down arrows

Pressure Dwell - Cycle speed (timer) adjust this by turning the dial

All start

All Stop

Cancel Cycle

Manual purge bottom die (not used)

Air pressure indicator - This should be 5bar/70psi

Hydraulic tons - this is an indication as the tonage the press is set to (10 tons) & is adjusted using the pressure adjust valve

Pressure adjust - This is used to adjust the pressure of the press (set to 10 ton). Clockwise to increase the pressure.

Pressing speed control - This is used to set the speed of the compression cycle (set to fast)

Tool set - This is used to close the press in free fall - *this must be closed before operating the press

Main control cabinet - Located at the rear of the press

Cycle start

Please Note - The electrical supply is 63amp, 3 phases & neutral, if the press has no function the phases will need to be changed as the pump will be running in reverse.

* The purchaser shall at it's own costs be responsible for disconnecting, dismantling and removing items purchased from the auction location. If the purchaser is intending to export items purchased at the auction it shall be responsible at its own cost for ensuring compliance with all UK export conditions and the obtaining of any applicable Export Licences.

* Please note all dimensions stated are approximate, however the accuracy cannot be guaranteed and should be verified by the bidder before bidding.

Recommended Transport